Release agent

Description

Mixed 500g/Mixed 200g

How to make mold release agent

1. Add mold release agent to empty bottle
   (Wide mouth container that can hold 1 liter or more, e.g. large instant coffee bottle, etc.)
2. Add water to the top. (Do not knead) Leave it for 1 to 2 days
3. Discard the tap water. (After powder dissipates)
4. Add water again, stir, and leave it for one day
5. Once the powder settles out, discard the tap water. Repeat this about two times or until it gets better.
6. Add water little by little until it has a suitable consistency. (When you lift the mixing stick, the horns will disappear within a few millimeters)

If the liquid is too thin, the mold release effect will be compromised.
If it is too thick, the release agent itself tends to peel off.

The concentration of the liquid depends on your preference.
The longer you leave it and and more you knead it, the easier it will be to use.
The release effect will improve if you let it sit for more than half a day.

How to use mold release agent

1. Practice for a few minutes before each use. (knead until the consistency of the liquid is even)
   Dip the winding wire in the liquid, pull it out, and knead it until it is evenly thick.
2. Insert the winding wire into the release agent liquid, apply a generous amount,
3. Warm the winding wire over a fire, and once the steam has disappeared, remove it from the fire.
4. Apply mold release agent for the number of pieces made in advance, warm them,
   It is best to keep it dry.
5. If you don't burn the attached mold release agent,
   it will work well if you melt the glass before rolling it.